Diff Help

[Mash13]

OK so I just built my xray t2r, and I think the front diff is too loose (but im not sure How tight do make the diffs?) the rear diff is quite tight, there is a bit of resistance turning the rear wheels in opp dirsctions but the front is very loose.

So whats the rule with building a ball diff? Any help would be much apprectiated!

[nexxus]

ok to check a diff hold the spur gear and one wheel on the diff in question (lean against it) and try to turn the other wheel, if you can move the other wheel, the diff is too loose and will slip.

If you find the diff is getting looser after a run, replace the thrust bearing.

[Mash13]

cheers nexx it was too loose. but shez all good now

[Big Kev]

mash13
i hope your going tom bring it to kwini on sunday

[Mash13]

yeah i will be if its on, hangin to get back on the track