mischief
18-05-2005, 08:13 AM
Hi all..
I was having a play with my Mini-T in a near by car park when i noticed my car didnt respond from time to time.
Sometimes steering, some times just the throttle.
I thought it was "glitching" but even with the controller up close, it still didnt work.
On investigation i found that the internals in the receiver & esc were full of dust & "sand" from the track..& bad solder joints.
Soldered it all up, hot glued it to seal the plug in place & now all is good.
Question, do you people use to seal up the area where the crystal sits in? just tape it over with elec-tape or something?
I was having a play with my Mini-T in a near by car park when i noticed my car didnt respond from time to time.
Sometimes steering, some times just the throttle.
I thought it was "glitching" but even with the controller up close, it still didnt work.
On investigation i found that the internals in the receiver & esc were full of dust & "sand" from the track..& bad solder joints.
Soldered it all up, hot glued it to seal the plug in place & now all is good.
Question, do you people use to seal up the area where the crystal sits in? just tape it over with elec-tape or something?