vxl esc

[Paul]

im having problems with my traxxas vxl speedie

i put my freshly charged 2s lipo pack in to the battery bay and plug it into the speedie

press the ezyset and it doesent do anything but the stearing servo sill works and you can still stear

BUT no throtle or anythig will work

nor the green/red light comes on to enishelize that the speedie is on

plz hepl

thanks
paul

[NightWolf]

have u followed setting the esc up to the tx rx
if i was heading up today id look at it buy might not be till next week

[Paul]

yeh kool nw hgow do i follow up the setting

[NightWolf]

1. Connect a fully charged battery pack to the VXL-3s.
2. Turn on the transmitter (with the throttle at neutral).
3. Press and hold the EZ-Set button (A). The LED
will first turn green and then red. Release the
EZ-Set button.
4. When the LED blinks RED ONCE. Pull the throttle
trigger to the full throttle position and hold it
there (B).
5. When the LED blinks RED TWICE. Push the throttle
trigger to the full reverse and hold it there (C).
6. When the LED blinks GREEN ONCE, programming
is complete. The LED will then shine green or
red (depending on low-voltage detection setting)
indicating the VXL-3s is on and at neutral (D).

[Paul]

now the light is still green alfter like 6 mins of being on

[g-maxx]

If the GREEN light is on after setup it means the lipo low volt safety cutout is ON.

If the RED light is on after setup it means the lipo low volt safety cutout is OFF.

Ive found on my VXL's that the setup button jams up occasionally, this can be fixed with a bit of silicone spray. But i just had to pull one apart on the weekend and ream the hole out to stop it from jamming.

:D RoKoN :D

[Paul]

yeh thanks guys i manahed to reset it and it work perfecty now :)