Highlucks XR10 Viper

[highlucks]

Hey guys I have been playing around with this one for some time now but wanted to keep it quiet until after Nationals. As always it had its teething problems to begin with. Two stock final gears and one HR shredded plus one bent rear axle. Five runs and four breaks I was doing very well :-x


XR10 kit bought secondhand. Replaced half the screws and the rear axle housing.

Bits List.

Under Ground Crawlers Viper Chassis
VP motor plates
VP housings
VP Knuckles
VP C Hubs
VP Lock outs
HR and Axial Gears - RC4WD on the way. I hope, I've been waiting a nearly a month for them now.
Custom Uppers and Lowers
6mm 4140 Custom rear axles ( Cant bend these )
D-lux Knuckle weights

Brood 35T Creep HHK Motors
Twin FXR's
CC BEC
Futaba S9157

Bigbores
30W oil
Mini T springs
JeepinDoug Spring Caps

VP SLW V3 1.0" Sedonas
VP SLW V4 1.0" Bossclaws

Krawler Hobbies 1300mah 3S
Rowdy Racing Front axle battery mount

Stainless steel skins, 0.125mm thick. Six times thinner that 0.030" lexan.

I will upload some build photos when I get home, but here are some photos from the comp on the week end. I will also have weights and widths when I get home from Sydney.

http://i929.photobucket.com/albums/ad138/nec871/cANZ-NationalCrawlingCompPics/IMG_3134.jpg

http://i929.photobucket.com/albums/ad138/nec871/cANZ-NationalCrawlingCompPics/IMG_3153.jpg
http://i929.photobucket.com/albums/ad138/nec871/cANZ-NationalCrawlingCompPics/IMG_3154.jpg

http://i929.photobucket.com/albums/ad138/nec871/cANZ-NationalCrawlingCompPics/IMG_3155.jpg

http://i929.photobucket.com/albums/ad138/nec871/cANZ-NationalCrawlingCompPics/IMG_3157.jpg

[remotebandit]

Sik

[highlucks]

Thanks Man

[Stewbaru]

Looking forward to seeing it over here, comp -wise